Hall of Wisdom



Remove this advertisement by REGISTERING.

Categories

Search Articles

Display Options

Showing articles 1 to 8 of 8

Hall of Wisdom

by Pancho Published on 07-20-08 03:16 PM
This one is simple,

Tools needed:
-25 torx
-30 torx
-10 mm wrench

First off all, remove the seat, after that remove with torx Nš25 the "false gas tank". For that you need to unscrew 10 bolts, 8 from "false gas tank" and 2 of the side fairing.
by Pancho Published on 07-20-08 12:41 PM
This procedure is quite simple and necessary for: deep cleaning of engine, air filter inspection/replacement, liquid cooling system inspection/refilling, further engine maintenance.

Notice that if you just want to reach cooler reservoir or air filter, you DON'T need to remove lower fairing, it's enough with the upper one.

So we need:
-N25 torx
-Phillips screwdriver
-flat screwdriver

I will show left side(air filter) removing, for the right(coolant reservoir) it's exactly the same.
by Pancho Published on 07-20-08 12:30 PM
This one is easy, but someone has to do it!

Tools needed: just a Phillips screwdriver!

What to do:

1- Unscrew the Phillips screw


2-Remove cover
by Pancho Published on 07-20-07 10:19 PM
To do this first be familiar with:
HOW:remove fairings on F800ST

Tools needed:
Torx N25
Phillips screwdriver
Flat screwdriver
Fingers:D

After removing false gas tank, and upper fairing (you don't need to remove lower fairing) you will see the air box and air box intake:
by Pancho Published on 07-20-07 10:00 PM
This procedure is quite simple and necessary for: deep cleaning of engine, air filter inspection/replacement, liquid cooling system inspection/refilling, further engine maintenance.

Notice that if you just want to reach cooler reservoir or air filter, you DON'T need to remove lower fairing, it's enough with the upper one.

So we need:
-N25 torx
-Phillips screwdriver
-flat screwdriver

I will show left side(air filter) removing, for the right(coolant reservoir) it's exactly the same.
by Pancho Published on 07-20-07 09:11 PM
This one is simple,

Tools needed:
-25 torx
-30 torx
-10 mm wrench

First off all, remove the seat, after that remove with torx Nš25 the "false gas tank". For that you need to unscrew 10 bolts, 8 from "false gas tank" and 2 of the side fairing.

Attached Image:
by Pancho Published on 07-20-07 08:42 PM
This procedure is indifferent for both calipers. It's wise to wear gloves, since brake pads get a lot of dust. If you have and air compressor, blowing air to them before disassemble it's really good. You don't have to remove neither the calipers or front wheel.

Tools needed:
-small pliers, those with small tips are ideal.
-any medium (let's say 10 mm) wrench.

Here's how to:
1- Localize the securing clips that prevents axles from falling, then move the axles so the loop of the clip...
by Pancho Published on 07-20-07 04:16 AM
This one is easy, but someone has to do it!

Tools needed: just a Phillips screwdriver!

What to do:

1- Unscrew the Phillips screw
Attached Image:

2-Remove cover

Most Read Articles

Most Commented Articles

Top Authors

Mokkybear (20)
Richard230 (20)
Rob (16)
avboden (10)
Pat H (10)
Pancho (8)

Article Forum v4.0 Copyright by BananaLive